1 results listed
Buhar sıkıştırmalı soğutma sistemlerinde doyma
çevrimleri, genleşme prosesini doymuş sıvı eğrisine, sıkıştırma
prosesini ise doymuş buhar eğrisine yaklaştırmak amacıyla
düşünülmektedir. Buhar sıkıştırmalı çevrimlerde kompresör ve
kısılma vanasındaki tersinmezlikleri azaltmak amacıyla
kullanılması düşünülen doyma çevriminin ekserjetik analizi
Engineering Equation Solver (EES) yardımıyla yapılmıştır. İş
gören akışkan olarak R410A’nın kullanıldığı düşünülmüştür.
Doyma çevrimlerinde kademe sayısının, toplam ve her bir
elemandaki tersinmezlik miktarı ve sistemin ekserji verimi
üzerine etkisi araştırılmıştır. Çok kademeli doyma çevrimlerinde
ekserji veriminin evaporatör ve kondenser sıcaklıkları ile
değişimi incelenmiştir. Elde edilen sonuçlara göre, bir kademeli
sistemden iki kademeli sisteme geçerken, tersinmezliğin daha
büyük oranda düştüğü, kademe sayısı üç veya dört olduğunda bu
iyileşme oranının azaldığı bulunmuştur. Çok kademeli doyma
çevrimlerinin uygulanılması ile tersinmezliklerin en çok
kompresörde, sonra da genleşme valfinde azaldığı belirlenmiştir.
En çok tersinmezliğe sahip çevrim elemanının kompresör en az
tersinmezliğe sahip çevrim elemanının separatör olduğu tespit
edilmiştir. Kademe sayısı 2, 3 ve 4 olduğunda, ekserji verimi bir
önceki kademeye göre sırasıyla %28, %6 ve %2,6 oranında
artmıştır. Kondenser sıcaklığı arttıkça ekserji veriminin azaldığı,
evaporatör sıcaklığı arttıkça ekserji veriminin yükseldiği tespit
edilmiştir.
Saturation cycle is proposed in order to approximate
the expansion process to the saturated liquid curve and the
compression process to the saturated vapor curve for vapor
compression refrigeration systems. Engineering Equation Solver
(EES) software was used for the exergetic analysis of the
saturation cycle, which is intended to reduce the irreversibility of
the compressor and throttle valve in vapor compression cycles.
R410A was selected as the working fluid. The effect of the
number of stages on total irreversibility amount, irreversibility
amount of each cycle member and exergy efficiency of system
was investigated in saturation cycles. The variation of exergy
efficiency with evaporator and condenser temperatures was
investigated in multi-stage saturation cycles. According to the
results obtained it was found that the decrease in irreversibility
occurred most as the transition from one-stage system to twostage system occurred. As the stage number was increased to three or four the decrease rate of irreversibility fell. It was
determined that the implementation of multi-stage saturation
cycles reduces the irreversibilities most in the compressor and
then in the expansion valve. It was determined that the
compressor has the most irreversibility among the cycle
members and the separator has the least irreversibility among
the cycle members. As the stage number was increased to 2, 3
and 4, the exergy efficiency according to previous stages were
increased as 28%, 6% and 2.6%, respectively. It was found that
as the condenser temperature increases exergy efficiency
decreases and as the evaporator temperature increases exergy
efficiency increases.
1.st International Conference Energy Systems Engineering
ıcese'17
Yusuf Ziya Akman
Halil Kürşad Ersoy