3B YAZICILARDA İNŞA PARAMETRELERİNİN ÜRÜN MUKAVEMETİNE ETKİSİ - THE EFFECT OF CONSTRUCTION PARAMETERS ON PRODUCT STRENGTH IN 3D PRINTERS
Gökhan Sur Emir Ömer Akbaş Tuğçe Yıldız
AbstractBu çalışmada, termoplastik filament ile ürün imalinde kullanılan üç boyutlu yazıcıda, örme parametrelerinin ürün mukavemetine etkisi deneysel olarak araştırılmıştır. Bu kapsamda farklı üretim parametreleri (inşa açısı, bölüm ızgara genişliği ve inşa genişliği) dikkate alınarak deney numuneleri üç boyutlu çizim programında modellenmiştir. Deney numunelerinin üretimi “Fortus 360 MC” hızlı prototipleme cihazı kullanılarak gerçekleştirilmiştir. Plastik hammadde olarak “ABS M30” ticari isimli termoplastik filament kullanılmıştır. Üretilen deney numuneleri ASTM D638.05/2008 standardına göre çekme testine tabi tutulmuştur. Deney verileri, yazıcıdan elde edilen numunenin üretiminde kullanılan üretim parametrelerinin, ürün yapısal dayanımı üzerindeki etkilerinin belirlenmesinde kullanılmıştır. Deney sonuçları, ürün mukavemeti üzerinde en etkili parametrenin bölüm ızgara genişliği olduğunu göstermiştir. İnşa açısı 30 ve inşa genişliği 0,016 mm sabit olduğu durumda; bölüm ızgara genişliği parametre değerinin % 50 oranında azaltılması, ürün akma mukavemetinde ~% 54 ve çekme mukavemetinde ~% 53 oranında iyileşme sağlamıştır. In this study, the effect of knitting parameters on product strength was investigated experimentally in three-dimensional printer used in thermoplastic filament production. In this context, different production parameters (construction angle, section grid width and construction width) were taken into consideration and the test samples were modeled in three-dimensional drawing program. The production of the test samples was carried out using the Fortus 360 MC rapid prototyping device. Thermoplastic filament with the trade name fil ABS M30 “is used as plastic raw material. Tensile test was performed according to ASTM D638.05/2008. The test data were used to determine the effects of the production parameters used in the production of the sample obtained from the printer on the product structural strength. The test results showed that the most effective parameter on the product strength was the section grid width. In the case where the construction angle is 30 and construction width 0.016 mm; decreasing the section grid width parameter value by 50%, improved the yield strength by 54% and tensile strength by 53%.